10/29/2023 0 Comments Propellerhead recycle 2.2.4 keygenIt reported that connection was a success and populated all of the correct radio parameters and downloaded 417 config settings. Telemetry started working when I selected the cu bluetooth incoming port at 57600. There had been 4 serial connections displayed. I dont mean a different baud rate, I mean a different serial connection entirely. The only way it could connect for the radio was to use a DIFFERENT port than what had been used by the computer to connect to the craft. I had red on both sides (ground control and on the craft) So i watched a few YouTube videos on getting telemetry working. After installing APM 2.0 8-18-18 version that was previously on my Mac, the Pixhawk WAS sending data to APM on my Mac and I could see the GPS, elevation, and the map was local to where i was, and I WAS receiving the audible disarm alerts, but telemetry was not working. I am having similar FTDI incompatible driver issue on my Mac 10.13.6 High Sierra, but with a twist.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |